Implementasi Lampu Peringatan Pada Perlintasan Tanpa Palang Pintu Kereta Api Berbasis Mikrokontroler
Implementation of Warning Lights at Microcontroller-Based Railroad Crossings
Railroad crossings are intersections of parcels between railways and roads. The issue that stands out at the level crossing is the high number of traffic accidents between vehicles and trains, especially at crossings that do not have a doorstop. This research has the aim to make a warning lamp with a microcontoler base as a control system. With the aim of reducing the use of manual systems in general that are used today. The advantage of this warning light control system is to reduce the number of accidents that occur and can be used for railroad crossings that still do not have a doorstop that has not been installed on the railroad crossing railroad tracks (illegal roads). This research will discuss the implementation of warning lights on crossings without a doorstop. This design process goes through several stages. The design of this warning light system is more focused on designing the timing system of warning lights on dual rail lines based on train speed. Then in this design consists of two parts that support each other, namely hardware planning (hardware) and software (software). Where the software created will control the hardware used through a microcontroller and this hardware will provide feedback (feedback) to the software so that the control system becomes a closed loop (closed loop). The appearance of the work system that is created will be monitored using a web monitoring display that is supportive and easy to understand. Although it has some delay in the process, the planned system has run well based on the average delay value. From the experimental results it was found that at node 1 the lowest delay with a distance of 100 cm from the object with a value of 1.8 seconds and the highest delay is 2.07 seconds with a distance of 225 cm. For node 2 the lowest delay with a distance of 100 cm from the object with a value of 1.83 seconds and the highest delay is 2.05 seconds with a distance of 225 cm. For node 1 the highest RSSI value is -109.5 dBm for a distance of 14 meters and the lowest is -126 dBm while for node 2 the highest RSSI value is -110 dBm for a distance of 14 meters and the lowest is -127.5 dBm. . The average measured delay on the system is 0.31 seconds before sending from the node and 0.49 seconds when there is a change in conditions whereas when there is sending data from the node. The measured packet loss on the system is 0% at the time before sending and the fan and 8.88% when sending data from the node.