Identifikasi Data Informasi Dari Sensor EC Dan PH Sebagai Uji Parameter Kualitas Tanah Berbasis IOT

Identification of Information Data from EC and PH Sensors as IOT Based Soil Quality Parameter Test

DICKY WAHYU CAHYO ARTIKO

Soil has a very important value in agriculture. Fertile soil can make crops on agricultural land grow well and produce abundant crops. To get fertile soil, farmers always apply fertilizer to the soil. However, this does not always make the soil fertile. So farmers have to test soil samples to a soil quality laboratory with relatively expensive costs and a long time. To make it easier for farmers to test soil quality easily, the authors conducted research on the Identification of Information Data from EC and pH Sensors as a test of IoT Based Soil Quality Parameters. The system consists of three types of sensors, namely the PM-WCS-3-I2C sensor as a sensor that measures soil conductivity, soil moisture and soil temperature, Soil pH sensor and DC Voltage sensor as a sensor that measures DC voltage on the soil. When taking soil measurements, the soil is placed in a container made of acrylic with two electrodes made of brass and aluminum and a probe pin made of brass. ESP32 processes data from the sensor which will be sent to Firebase in realtime. The data sent will be stored in the database in the form of a table in phpMyAdmin. The test results concluded that the PM-WCS-3-I2C sensor can measure the Electrical Conductivity of each soil sample. Soil only with compost mixture had the most stable soil quality of the three soil samples with a sodium cation capacity of 0.4 – 0.7 cmol(+)/kg and a sodium cation exchange rate of 5% - 10%. The best QoS value was on Thursday, 08/07/2021 with the average delay, packet loss and throughput of 0.950922 seconds, 0% and 815.062537 bytes/s.

Subjek

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.19.1 · c557b04