Implementasi Sistem Otomasi Suhu dan Kelembaban pada Greenhouse Berbasis Sensor Dht22 Dengan Sumber Plts Di Area Javan Langur Center
Implementation of Temperature and Humidity Automation System in Greenhouse Based on Dht22 Sensor with Plts Source in Javan Langur Center Area
On the Javan Langur Center area has a greenhouse which is still traditional. Where there is no temperature and humidity controller that supportsthe process of planting in the greenhouse. While the environment is the most important factor in the world of agriculture because environmental conditions willaffect the success of the quality and quantity of plants. One of the most influential factors in plant growth is temperature and humidity. Based on this problem, the temperature and humidity values were adjusted in the green house area of the Javan Langur Center. The methodology used in setting temperature and humidity is to make temperature and humidity control automatically using a water flash system. The manufacture of this temperature and humidity control device is usefulfor lowering the temperature and increasing the humidity in the greenhouse areaof the Javan Langur Center. Design and assembly of temperature and humidity control in greenhouses at Javan Langur Center using the DHT22 sensor as areader or automatic temperature and humidity detector. When the temperature rises with a setpoint >25˚C then the sensor will send a signal to the Arduino to be processed into a digital signal which will later be read by the LCD and also the Arduino sends a signal to the Buzzer as an alarm and the relay will activate to activate the water pump. The water pump will spray throughout the room to lower the room temperature and increase the humidity in the room with a spray time of 1 minute. Temperature and humidity control devices that have been designed and tested in this study can regulate temperature and humidity conditions. By calculating the average error value of 0.02%. As for the error value on humidity found an average of 0.00 - 0.16%. In this case, the accuracy value of a sensor can be seen from the error value which shows that it is not too high