Sistem Kontrol Suhu Extruder Mesin Molding Microplastic Metode PID Berbasis PLC

Molding Machine Extruder Temperature Control System Microplastic PLC Based PID Method

MOH. RISKI APRIANTO

The development of increasingly sophisticated technology in the printing industry of plastic goods resulted in an increase in the demand for production in a short time. One way to solve the problem is to make injection molding machine. Microplastic molding machine is an injection molding machine that aims for learning media with reduced size but the same working principle. One part of microplastic molding machine to note is the temperature on the extruder. The temperature in the extruder is heated by a band heater and keeps the temperature cooled so that the plastic material used can be melted perfectly. The plastic material used is HDPE (High Density Polyethylene) which is crystalline and has a melting point above 130 °C. Full temperature microplastic molding machine using PLC (Programmable Logic Controller). The method used in PLC is pid method. From pid testing conducted obtained value Kp = 51.19, Ki = 0.0003, Kd = 1894030. And in PID testing obtained the time difference to reach the setpoint by 2 minutes slower than the band heater directly given the AC voltage 220 V. In the test results obtained the right temperature to the printout is a temperature of 180 °C

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.20.5 · 33e0fa7