Pengaruh Static-Transient Thermal Tensioning dan Preheating terhadap Distorsi Sudut pada Pengelasan FCAW Sambungan Corner Joint Baja SS400
The Effect of Static-Transient Thermal Tensioning and Preheating on Angle Distortion on Corner Joint of Steel SS400 FCAW Welding
The process of the FCAW welding is an automatic welding process that utilizes a wire roll electrode to melt the metal, on these FCAW welding protective types used are the flux or powder that is in the nucleus of the elektrode. The most common problems when using the FCAW welding method is the presence of angular distortion and the alteration of the length and width dimensions, especially for the thin plate iron material, due to the residual voltage arising from the welding process. The purposes of this research are to know the influence of static thermal tensioning and preheating, as well as a combination of static-transient thermal tensioning and preheating against angular distortion in the SS400 steel corner joints, welding by means of heat input during the welding process. The method of research used is true experimental research, is a research by providing treatment, with a variation of the preheating temperature of 200°C, 250°C, 300°C, static thermal tensioning 150°C, 200°C, 250°C, transient thermal tensioning 150°C, 200°C, 250°C and no method as reference point in determining the result of welding method which can minimize the occurrence of angular distortion. The Material used in this study was steel SS400 with a thickness of 3mm. Data processed using Minitab 18 software using One Way Anova method. The result of this research is there is a significant influence of static thermal tensioning welding methods, preheating and the combination between the two methods. In this research can be concluded that the good welding method is preheating-static thermal tensioning 89°55', preheating-transient thermal tensioning 89°50', static thermal tensioning temperature 150°C 89°45 ', transient thermal tensioning 150°C 89°40', Preheating 200 °c 89 ° 35 '.