Studi Eksperimen Pengaruh Variasi Kuat Arus dan Kecepatan Pengelasan TIG terhadap Kekuatan Tarik Sambungan Las pada Material AISI 304

Experimental Study the Effect of Variation of TIG Welding Current and Welding Speed on the Tensile Strength of the Welding Joint of AISI 304

YOUAN BAGUS TAMARA BEI PRABOWO

TIG welding results are highly dependent on welding speed and current variations. It is necessary to have the right combination of these factors to produce the highest tensile strength value in the welding results on steel. This study aims to determine the effect of variations in current strength and welding speed on the tensile strength of steel. Experimental tests were used as the research method. Stainless steel AISI 304 was used as a material object. Variations Welding currents were 100 A, 120 A, and 140 A. The welding speed was 1 mm/s, 3 mm/s, and 5 mm/s. The results of this study showed that the highest tensile strength was found at a current of 120 A with a welding speed of 1 mm/s, which was 522,02 N/mm2. In comparison, the lowest tensile strength was found at a current of 120 A with a welding speed of 5 mm/s of 111,53 N/mm2. It can be concluded that welding speed of 3 mm/s has the highest tensile strength. Meanwhile, the current 120 A has the highest tensile strength.

Subjek

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.20.5 · 33e0fa7