Analisa Unbalance dengan Unbalance Load Flow dan Komponen Simetri berbasis DBMS (Database Manajemen System) di Gedung Sipil Politeknik Negeri Malang
Analyze Unbalance with Unbalance Load Flow and Symmetrical Component based on DBMS ( Database Manajement System ) on Sipil Building State Polytechnic of Malang
Power quality problems have become a major problem in the electrical power system. One of the factors is the unbalanced power flow. According to SPLN D5.004-1: 2012 (Page 17) Paragraph 9 states that voltage unbalanced is cause by unbalanced inter-phase loads due to load differences between phases. In the case on Civil Building, the unbalanced voltage and current is caused by the uncoordinate installation of loads, causing an unbalanced voltage and current in each phase. As results the protection equipment in the civil building not functional optimally and there is a neutral current on the outgoing side transformer. According to the IEEE (Institute of electrical and electronic engineer) number 4461980 for load unbalanced the allowable range value is between 5% and 20% in all phases. While the voltage unbalanced on each line, the allowable value limit is a maximum of 2.5% of the average voltage value. Based on the measurement results, it was found that the neutral current flow on the outgoing side of the transformer was 45.27 A with the largest voltage and load unbalanced on the Main Distribution Panel of 29.51% and 49.12% at 07.00. it can be seen that the neutral current generated due to unbalanced at 07.00 is 44.94 A. Meanwhile, the analysis using the symmetric component method also shows that the 3-phase system in civil buildings sustained an imbalance. It can be verified that there are values for the components of the positive, negative and zero sequence.