Rancang Bangun Modul Control SPWM Berbasis Arduino Uno
Design of SPWM Control Module Based on Arduino Uno
Electronics in the world has progressed and developed, one of which is the use of DC electrical energy which is converted into AC electrical energy called an inverter. One technique for obtaining pure sine waves from DC wave conversion is to modulate the width of the DC wave pulse signal. This technique is called sinusoidal pulse width modulation (SPWM). In final project inverter has been successfully designed using the SPWM technique as a switching process. The method of making a 1-phase MOSFET IRFZ44N full bridge inverter to produce SPWM waves is to change the voltage from 24 VDC which is then increased by using a Step Up transformer and capacitor as a filter using 1kHz input frequency from Arduino uno. From the test results, it is obtained SPWM with an input voltage of 24 VDC and a frequency of 1KHz and an inverter output voltage of 188.3 VAC without load and 135 VAC using a 3 Watt load in the form of a lamp.