PID Controller Level Feedwater Boiler Pada Miniplant Dengan Mengunakan PLC dan HMI Untuk Pengembangan Laboratorium Kontrol
PID Controller Of Feedwater Boiler Level in Miniplant Using PLC and HMI Control Laboratory Development
Abstract – Along with the development of the times and technology can not be denied again that need of electrical energy is increasing. So that, to produce the large electricity needs in Indonesia, electric power plants are made such as the PLTU. In the process of changing the water into steam it is not possible to work well. Controls often occur such as output that is not as desired such us volume of water too high or low and temperature under or upper of setpoint. Therefore, this study aims to design a feedwater level control system with the PID method so that it can produce a stable system response. In addition, PLC and HMI were chosen as controllers to facilitate feedwater level settings in this study. In the research that have been done, the analysis results are obtained, namely feedwater level according to the setpoint is 20 cm, due to the influence of the PID constant which affects the pump motor. In determining the PID parameters used two ways, namely the Ziegler-Nichols 1 method and manual tuning. The best response results when using Ziegler-Nichols 1 method is Kp = 21,6, Ti = 24s, and Td = 6s resulting good enough with rise time is 135s, settling time is 152s and ESS is 2cm. So that, using manually tuning with parameter values of Kp = 12, Ti = 0,01s, and Td = 0,03s. From that, is obtained the good response of level control with accurate value 99,75% and settling time 129s.