Modul Implementasi Kontroler PID Pada Pengontrolan Kecepatan Motor Pompa DC Untuk Kontrol Level Feed Water Heater Menggunakan PLC
PID Controller Implementation Module at Speed of Motor Pump DC for Control Level Feed Water Heater on PLC
In general post-harvest handling of agricultural products will cause difficult problems often faced by farmers, especially when the product is abundant as chili. Agricultural products are generally a product that is easily damaged if not immediately done post-harvest handling. Drying using traditional methods by utilizing solar energy is still somewhat inefficient because it requires a very wide place, a relatively long time and depends on weather conditions. Therefore in the design of chili dryer machine that uses a hybrid system. The advantages of this machine is made like an oven model and rack type, using a hybrid system that has a combined meaning of energy sources by utilizing solar energy and electrical energy will help farmers in the problem of cost and time required to dry the chili does not require a very long time dry with the traditional method. In the experimental results can be analyzed that the temperature stability and constant value on the PI greatly affect the dryer and the results of chillies tested. The use of PI makes the dryer more stable. This drying machine can choose the source to be used by utilizing sunlight or using electrical energy. This machine will stabilize the temperature with the desired set point. By Ziegler nichols method, the temperature value of set point 70°C with the best PI constant of experimental results so far is: Kp = 15, Ki = 0.19 with a fairly stable response with oscillation of deviation of 0.3°C from the setpoint.