Sistem Kerja, Pengetesan dan Troubleshooting Automatic Direction Finder System pada Pesawat B-737 NG

Working System, Testing and Troubleshooting Automatic Direction Finder System on B-737 NG Aircraft

MOCH. KUKUH FIRMAN SATRIYO

Navigation of the Radio Direction Finding (RDF) on the first aircraft developed was an Automatic Direction Finding (ADF) navigation system. The ADF uses the Low Frequency (LF) frequency band using the frequency range of 190 to 1750 kHz. In order for this system to work properly it is supported by several supporting components such as antenna, receiver, control panel and audio control panel. Although this navigation system is currently replaced by GPS, however, in all the latest aircraft there is still an ADF system. On the latest aircraft, the ADF functions as a backup navigation system if the GPS system fails. It is important to keep the ADF functioning properly during flight. Regular testing and maintenance is done to maintain the performance of the ADF system. The ADF test can see factory-defined procedures in the Aircraft Maintenance Manual (AMM) and Fault Isolation Manual (FIM). In working on a plane, technicians must always be guided by the two documents. Tests for the ADF system on aircraft can use IFR4000 test equipment, this test tool can test 3 parameters contained in the ADF system. These 3 parameters are bearing accuracy, audio function and to / from function. BITE tests were also conducted on the ADF receiver components, procedures and guidelines for implementing BITE this test is on the FIM B-737 NG 34-57 TASK 801. After finding the source of the problem that occurred in the ADF system, maintenance practices can be carried out by replacing the problematic ADF components, the processes and procedures for replacing are regulated in AMM documents chapter 34-57-03 / 401 and 34-57-03 / 404 .

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.17.5 · 54e4f54