Perancangan Ulang Buck Dan Boost Converter Pada Prototipe Pembangkit Listrik Tenaga Bayu Savonius Di Politeknik Negeri Malang
Redesigning Of Buck And Boost Converter On Savonius Wind Powered Power Plant Prototype In Polytechnic State Of Malang
DAVI YUKASYAH ANWAR, EKO PRASETYO DADANG SISWANTO
PLTB is a power plant that uses a renewable energy, which is wind as its energy source. It means that the use of the energy would not reduce the wind resource as in the case of fossil energy source. In order to run, the PLTB requires converters to convert DC current (one way) into other DC current. This paper aims to redesign Buck and Boost Converter in PLTB Savonius and test the voltage of Output Buck and Boost Converter in the PLTB. The research is conducted at PLTB Polinema Malang and Building AH Polinema Malang. Data collection methods used are observation and literature study. Based on the data collection on the existing converters, the converters used in the Polinema's PLTB require an improvement due to it's low efficiency. Hence, the converters will be redesigned into a buck and boost converter to optimize the PLTB's performance. Design method used is through the construction of a prototype as a material and a laboratory trial analysis using a power supply is performed to know the output of the buck and boost converter. If the converters testing indicates a good result and shows no disturbances then a follow up test could be done in the PLTB Savonius's system to obtain the real data. According to the testing results, the research has succeeded in designing converters for small scale turning. In addition, the buck and boost converters could stabilize 14V voltage in an output range of 6 - 35V.