Analisa Kadar TSS, COD, pH, dan Turbidity dalam Pengolahan Leachate dengan Metode Elektrokoagulasi Kontinyu
Analysis of TSS, COD, pH, and Turbidity Levels of Leachete Processing with Continuous Electrocoagulation Method
Garbage has characteristics that can cause pollution to the environment, if not managed properly it will affect the level of cleanliness and pollute the environment. Waste that is distributed to the TPA takes time to process so that it allows the accumulation of waste. The presence of piles of garbage in the landfill can cause waste to decompose which releases water called leachete. Leachete can seep into the soil causing direct contamination of soil and groundwater because in leachete there are various organic and inorganic chemical compounds as well as a number of pathogens. The presence of leachate from the pile of garbage is one of the main environmental polluting factors produced by piles of garbage in the landfill. This study aims to determine the effect of feed flow rate and voltage used to determine leachate processing on the levels of TSS, COD, pH, and turbidity. The method used in this study is a continuous electrocoagulation process with variations in feed flow rate (300 and 500 ml/min) and voltage variations (6 and 9 Volts). From the results of the analysis of TSS, COD, and pH the most effective feed flow rate of 300 ml/minute with a voltage of 9 Volts decreased by 75% (TSS), 83% (COD), and 22% (pH). The most effective turbidity feed flow rate is 500 ml/minute with a voltage of 6 Volts decreased by 80% (turbidity). Furthermore, from the results of the analysis of TSS, pH, and the most effective voltage turbidity used is 9 Volts with a feed flow rate of 300 ml/minute which has decreased by 75% (TSS), 22% (pH), and 80% (turbidity), while in COD analysis, the most effective voltage used was 6 Volts with a feed flow rate of 300 ml/min decreased by 83%.