Development Of Automatic Navigation System On Uav (Unmanned Aerial Vehicle) With Gps Waypoint
Development Of Automatic Navigation System On Uav (Unmanned Aerial Vehicle) With Gps Waypoint
UAV is one of the Unnamed Aerial Vehicle in the air that can fly without a pilot, use aerodynamic forces to produce lift force, can fly autonomously or operated with radio control. UAVs are used for a variety of purposes both in the military and civilian sphere.In this final task designed and realized the development of automatic navigation system on UAV with GPS waypoint.The system uses manual control and autopilot.In manual mode, the user manually controls the movement of the aircraft through the controller radio while in the autopilot mode the aircraft is controlled by the Arduino Mega 2560 microcontroller that processes the IMU (Inertial Measurement Unit) sensor data which includes a gyroscope and accelerometer, GPS and barometric altimeter so that it can fly automatically according to the GPS waypoint entered. The microcontroller receives and intercepts data from the sensor and generates output to drive the actuator servo. Processing data from sensors using PID (Proportional Integral Derivative) control. The aircraft will be connected to the ground station via telemetry devices to transmit flight data to the ground. The navigation system is expected to precisely steer the aircraft towards one or more points with fault tolerances f 30 meters at an altitude of 30-100 meters. In addition, the aircraft is expected to fly with a radius of ± 2 km from the ground station. The results of the test can be carried out manual and automatic control on the UAV through 5 channels (aileron, elevator, throttle, rudder and switch). Distortion in manual control is minimized by enlarging the PWM signal divider factor by 50¿s-100¿s. Automatic control can stabilize the aircraft's airborne attitude (45° roll angle and 30° pitch angle) Kp 1.2 and Ki 0.01 settings, GPS navigation Kp settings of 0.2 Ki 0.01 and Kd 4 with a maximum roll angle of 15°.