Surface Modification of Zeolites with Phosphonic Acids for Gas Adsorptive Separation

Salvira Permanaputri

In recent decades, the globe has grappled with the issue of climate change due to the escalating levels of CO2 emissions. A practical approach to mitigate CO2 emissions involves using various adsorbents to separate and convert CO2 into valuable fuels. Carbon capture systems are a highly efficient method for decreasing CO2 emissions. Zeolite is an effective adsorbent for capturing CO2. Zeolites possess valuable features, including their crystalline structure and chemistry, which render them highly useful as adsorbents or catalysts in various industrial applications. Zeolite exhibits a wide range of varieties, and one of the effective zeolites for capturing CO2 is known as zeolite 5A. The present investigation utilized ball milling and acid treatment methods as experimental modification techniques to enhance the adsorption capacity of zeolite 5A using noctadecyl phosphonic acid (ODPA) solution. The properties of pristine 5A and modified zeolites were determined using FT-IR and XRD analyses. The XRD study reveals a minimal disparity between the modified and pristine zeolite. The FT-IR analysis did not show any notable differences in each sample. However, no peak was detected in the 773- 775 cm-1 range in the 5A−0.1M ODPA sample. The breakdown of Al and O bonds in the zeolite framework is caused Al-O react with ODPA to remove the water. Subsequently, the concentration of ODPA was optimized as it was identified as the preferred modifying agent. The study also utilized the computational method of DMol3 . A comparison was made between the performance of pristine 5A, 5A−0.05M ODPA, and 5A−0.1M ODPA. The CO2 adsorption capacity of pristine 5A is 2.14 mmol/g, whereas the 5A−0.1M ODPA has a capacity of 2.24 mmol/g at a temperature of 298K from 6.61% of the total sample. The acid modification of zeolite increased the CO2 adsorption capacity in the 5A−0.1M ODPA sample at a temperature of 298K, demonstrating its effective capture capabilities. The DMol3 computational technique was used to conduct a simulation using the isotherm module. The results indicate that 298 K is the most suitable temperature for CO2 capture, corresponding with the experimental findings

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.19.1 · c557b04