The Influence of Temperature and Screw Rotation Speed on Diameter Irregularity in Single Screw Plastic Extruder Machine Using Recycled PLA Plastic Material
Plastic waste poses a significant environmental challenge, particularly with its growing accumulation in oceans and landfills. Recycling polylactic acid (PLA), a biodegradable polymer widely used in 3D printing, offers a promising approach to reduce this impact. This study investigates the influence of extrusion temperature and screw rotation speed on the diameter irregularity of recycled PLA filament produced using a single-screw plastic extruder. Experiments were conducted with three temperature settings (150°C, 160°C, 170°C) and three screw speeds (20, 30, 40 rpm), each combination repeated four times with ten diameter measurements per filament. Data analysis employed Two-Way ANOVA, X̄ and S control charts, and response optimization using Minitab software. Results indicate that both temperature and screw rotation speed significantly affect filament diameter, with screw speed showing a slightly stronger effect. The optimal condition for achieving a consistent, near-target diameter was at 160°C and 30 rpm, producing smooth melt flow and stable feeding, with a predicted diameter close to 1.75 mm and high desirability. These findings highlight that precise control of extrusion parameters can enhance the quality of recycled PLA filament, supporting more sustainable 3D printing practices.