Optimization of Injection Molding Parameters in Mold Sm20 using the Taguchi-Grey Relational Analysis (GRA) Method for Reducing Short-Shot Defects and Cycle Time

Abraham Thiong Ajak Thion

Baca

Abstrak

Injection molding is a critical manufacturing method used to produce highprecision plastic parts with high repeatability and efficiency. However, the process often encounters defects such as short-shot and long cycle times, which negatively impact product quality and production throughput. This study aims to optimize key process parameters nozzle temperature, injection pressure, and injection time each varied at four levels, to reduce short-shot defects and minimize cycle time in the use of Mold SM20. The optimization approach utilizes the Taguchi method with an L16 orthogonal array to design the experiments efficiently while minimizing the number of trials. Furthermore, Grey Relational Analysis (GRA) is employed to perform multi-response optimization, allowing simultaneous evaluation of two performance objectives: defect reduction and cycle time improvement. The GRA method normalizes experimental data, calculates grey relational coefficients, and derives a grey relational grade to determine the optimal combination of parameters. By integrating Taguchi and GRA, the study provides a systematic and data-driven strategy to improve both product quality and manufacturing efficiency. The results of the study showed that injection pressure had a significant effect on the combined short-shot response and cycle time (in form of GRG), while nozzle temperature and injection time did not have a significant effect. The combination of factor levels that results in the highest average GRG and thus the best overall process performance is as follows: Nozzle Temperature: 225°C (Level 3), Injection Pressure: 55 bar (Level 4), Injection Time: 2.0 seconds (Level 1) which produces an optimum GRG of 0.841278.

Kata kunci

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.16.2 · 33935d3