Power Quality Analysis Of Electrical Installation At Comemercial Centre Case Study Of A Shopping Centre

Akuak Ayor Akuak

Introduction of new electronic technologies that are more sensitive to disturbances in the power network has made it necessary to monitor the quality of power supplied. This project presents a study of the power quality at the shopping mall, and aims at identifying the causes of poor power quality and provide the solutions to these power quality problems. The main objective of this project is to analyse the power quality of the electrical power system of the shopping mall in order to identify the causes of poor power quality and provide solutions to improve the power quality. Furthermore, for all the specific goals that had been set before the commencement of this project have all been accomplished. The most common power quality issues in most electrical networks include voltage unbalance, current unbalance, voltage harmonic distortion, load unbalance, and current harmonics distortion. Other power quality issues that can be experienced include voltage flicker, inter-harmonics, brownouts, direct current, short-term and long-term power interruption. A discussion of some these issues has been conducted in this report with their impacts on equipment in the network identified to be overheating, tripping of circuit breakers, and improper functioning of equipment. The compensating devices that can be used for improving power quality such as Active and Passive filters have also been analysed in this report. IEEE 519, AS/NZS 61000.3.2.2003, ANSI C84.1, IEEE 1459, EN 50160, and IEC 61000 are some of the power quality standards that have been discussed in Power Quality Analysis at this shopping mall. Based on the data collected from the shopping mall, particularly from 1.44 DPB. Subsequently, the power quality problems experienced at the mall include voltage unbalance of 0.01 or 1 % based on NEMA and IEC formula respectively, a 7 % current unbalance, distortions in current angle, current harmonic distortion in the range of 10 to 35 %. However, the main problem at the mall was the current harmonic distortion and so, 200A Active harmonic filter was sized and installed to filter and reduce the total current harmonic distortion. The electrical power system of this mall was also modelled in ETAP and the harmonic analysis was conducted.

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.19.1 · c557b04