Pengaruh Waktu dan Rapat Arus dalam Proses Anodizing pada Aluminium 6061 terhadap Kekerasan Permukaan
Pengaruh Waktu dan Rapat Arus dalam Proses Anodizing pada Aluminium 6061 terhadap Kekerasan Permukaan
Aluminum is one type of metal material that is widely used. Application of aluminum type 6061 that is on carabiner. The use of carabiners that rub against each other can trigger the occurrence of eroded layers. The condition causes the mechanical capability of aluminum to decrease, it takes the hardness of the surface layer. It is necessary to do the treatment method that is by anodizing method that aims to improve the physical and mechanical properties of aluminum. The purpose of this study is to determine the effect of current tightness and time on the anodizing process on the surface hardness of the oxide layer. The research method used is an experimental method using aluminum specimens 6061 carabiner measuring 25 mm x 50 mm x 8 mm. The current variations used are 1, 2, 3, 4, and 5 A/dm2 and the time variations used are 40, 45, 50, 55, and 60 minutes. Testing is conducted using vickers micro hardness testing machine and for data processing using annova two-way method. The results of this study showed that the lowest surface hardness value was produced at a process time of 40 minutes with a current of 3 A/dm2 of 118.3 VHN. The highest surface hardness value is generated from a 55 minute processing time with a current of 5 A/dm2 of 166.7 VHN. The conclusion of this study is that with increasing time, it will increase the value of surface hardness unless there is a decrease in 60 minutes. The best current to increase hardness is at 5 A/dm2.