Studi DC-DC Buck Boost Converter Menggunakan Pengendali Sliding Mode Control Pada Charging Baterai Sebagai Daya Suplai Motor Servo Untuk Penggerak Valve Kompor Gas Pada Miniatur Proses Pirolisis Di Lab Gedung AK Prodi Teknik Listrik

Study of DC-DC Buck Boost Converter Using Sliding Mode Control on Battery Charging as Servo Motor Supply Power for Valve Driven Gas Stove in Miniature Pyrolysis Process in AK Building Lab Electrical Engineering Study Program

PRIASMA CHANDRA PRATAMA

In the new era modern, the use of plastic waste is widely used to support human life, one of which isplastic waste Polyethylene Terephthalate (PET). Pyrolysis is a thermodynamic decomposition process from plastic waste which is converted into alternative fuels. While the PLTS process to the pyrolysis process is optimal and stable solar radiation that leads to PV, which then outputs the voltage from the PV into the MPPT/DC-DC Converter which is needed as a place to stabilize the voltage for theprocess charging to the battery. Buck-boost converter is an electronic circuit that can increase and decrease the value of the output voltage from the PV to the battery. The voltage value can be adjusted by changing thevalue duty cycle. In the buck boost converter there are several types of controllers, one of which will be used in this study is Sliding Mode Control. Sliding Mode Control is acontrol technique non-linear that has robust properties against disturbances and parameter changes. The method that will be used for the buck-boost converter and MPPT uses Simulink MATLAB 2020a. Based on the results of the MPPT simulation, the results of the comparison of the output voltage with hardware, solar radiation affects the voltage, current and power generated by PV. For the simulation of the buck-boost converter without sliding mode control, the output voltage waveform is unstable and overshoot, while the buck-boost coverter with sliding mode control has an overshoot at a settling time of 1.5 milliseconds (very fast) with the output voltage returning stable at 12.64 V.output voltage regulation Buck boost converter without SMC using duty cycle/pulse generator while Sliding Mode Control uses iLref and Vref as reference for the desired output voltage. The results of this simulation experiment Buck boost Converter using Sliding Mode Control is more stable than without Sliding Mode Control.

© 2026 UPA Perpustakaan POLINEMAStatus LayananKebijakan PrivasiSyarat & Ketentuan

v2026.11.19.1 · c557b04